Wen 3620, Инструкция по эксплуатации

Страница: 6 / 22

1. TOOL PURPOSE. This circular saw is designed to cut through softwood only. Cutting other materials
could result in fire, injury, or damage to the workpiece. Using the machine for any other purpose for which
it is not designed may result in serious injuries, machine damage and voiding of the warranty.
2. CHECK THE BASE PLATE FOR PROPER MOVEMENT BEFORE EACH USE. Press the blade release but-
ton to make sure the base plate can move freely and does not touch the blade or any other parts. DO NOT
operate the saw if the base plate does not move or does not open and close smoothly. Dropping the saw
may cause the base plate to not work properly.
3. PERSONAL SAFETY.
• Always wear ANSI Z87.1-approved glasses with side shields, hearing protection and a dust mask.
• DO NOT wear loose clothing or jewelry, as they might get drawn in by the tool. Tie back long hair.
• DO NOT wear gloves while operating this machine.
4. ELECTRIC CORDS. Keep cords away from heat, oil, sharp edges, and moving parts of the tool. Have an
electrician replace or repair damaged or worn cords immediately.
5. TOOL INSPECTION. Before operation, check the tool for any damaged or missing parts. Do not use the
tool if any part is missing or damaged. Do not use the tool if the power switch is faulty, the plug or cable is
damaged, or the tool produces sparks, smoke, or unpleasant odors (you may smell brushes wearing down
for a few minutes as the tool breaks in during the first use, that is normal). Make sure all adjustments are
correct and all connections are tight.
6. SECURING THE WORKPIECE. Use clamps to secure the workpiece whenever possible to prevent wob-
ble, damage to the workpiece, and personal injury. Never hold a piece being cut in your hands or across
your legs. It is important to support the work properly to minimize body exposure, blade binding, or loss
of control.
7. STANDING POSITION. Keep your body positioned to either side of the saw blade, but not in line with
cutting path. Kickback could cause the saw to jump backwards.
8. STARTING THE TOOL. Always start the saw before the blade is in contact with the workpiece. Let the
blade reach full speed before using the tool. The reaction to the torque as the motor accelerates to full
speed may cause the tool to kick back.
9. KEEP HANDS AWAY. Keep hands away from the cutting area and the blade. Do not reach underneath the
workpiece. The blade guard cannot protect you from the blade protruding from the underside of the work-
piece. Do not attempt to remove cut material when the blade is moving.
10. DURING OPERATION. Do not apply excessive pressure to the tool. Overstressing the tool may cause
kickback and damage the tool and accessories. Use special care when working corners, sharp edges etc.
11. TURNING OFF THE TOOL. The blade coasts after the saw is turned off. Wait until the blade comes to a
SPECIFIC RULES FOR THE MINI CIRCULAR SAW
WARNING:
Do not let comfort or familiarity with the product replace strict adherence to product
safety rules. Failure to follow the safety instructions may result in serious personal injury.
6