13
ADJUSTMENTS
WARNING:
To prevent injury from accidental operation, make sure the tool is switched OFF and un-
plugged from the power source before assembling the tool or making any adjustments.
ADJUSTING THE TABLE TRAVEL
The milling machine’s worktable can be adjusted along the X axis and Y axis to accurately set the cutting location.
The gauge on each handwheel indicates the distance of travel.
ADJUSTING THE BEVEL ANGLE
The machine’s bevel angle can be adjusted up to 45 degrees to
the left and right.
1. Loosen the bevel lock nut on the back of the machine using
the large wrench. Keep hold of the column to prevent it from
falling.
2. Adjust the bevel angle as indicated on the bevel gauge.
3. Fully tighten the lock nut with the M36 large wrench to secure
the bevel angle setting.
ADJUSTING THE HEADSTOCK HEIGHT
For normal feeding, the handle clutch (Fig. 5 - 1) should in the
Normal
Adjustment
Fine
Adjustment
1. To move the table along the cross (X) axis (left and right),
loosen the cross feed lock lever (Fig. 4 - 2), and rotate the cross
handwheel (Fig. 4 - 4). Tighten the cross feed lock lever to lock
the cross travel.
2. To move the table forward and back along the longitudinal (Y)
axis, loosen the longitudinal feed lock lever (Fig. 4 - 3), and
rotate the longitudinal feed handwheel (Fig. 4 - 1). Tighten the
longitudinal feed lock lever to lock the longitudinal travel.
NOTE: The lock lever can be pulled outwards and repositioned
on the screw.
1
1
3
2
4
3
4
2
outer position, disengaged from the pinion (Fig. 6 - Normal Ad-
justment). Rotate the feed handles (Fig. 5 - 2) to bring the head-
stock up or down. Use the depth gauge on the left of the column
to calculate the cutting depth.
For fine feeding adjustment (down to 0.001 inch increments),
push the handle clutch into the pinion (Fig. 6 - Fine Adjustment).
Rotate the fine feeding wheel (Fig. 5 - 3) to make fine adjustments
to the headstock position. Use the fine adjustment gauge to calcu-
late the cutting depth.
Fig. 4
Fig. 5
Fig. 6
Содержание 33013
Страница 18: ...EXPLODED VIEW PARTS LIST 18 Cross X Axis Longitudinal Y Axis...
Страница 19: ...EXPLODED VIEW PARTS LIST 19 Vertical Z Axis...
Страница 20: ...EXPLODED VIEW PARTS LIST 20 Spindle and Gear Box...
Страница 24: ...THANKS FOR REMEMBERING...