7
Owner’s Manual
WPC-15000 / WPC-15003
Maintenance
FILTER CLEANING
(See Figures 7 and 8)
There are three
fi
lters in the unit. The evaporator
fi
lter is located at the front of the unit. The
condenser
fi
lters are located at the side of the unit.
1. loosen up 2 bolts on the front
fi
lter guard.
2. Slide
fi
lter up and use a vacuum cleaner to remove the dust from the
fi
lter.
3. If the
fi
lter is heavily covered with dust and dirt, warm water and mild soap or neutral deter-
gent may be used to wash the
fi
lter. Do not use any other chemicals to clean
fi
lter, as they will
likely damage the
fi
lter.
4. Dry the
fi
lter in a shaded area before replacing it. Do not operate the unit without the
fi
lter
installed and the
fi
lter guard in the closed posi on.
5. Replace the clean
fi
lter and close the
fi
lter guard.
6. To clean the condenser
fi
lters, li up on the side
fi
lters from the middle bar slightly and then
angle the
fi
lters outwards from the bo om and remove.
7.Use the same cleaning procedure as above (3 – 5).
8. To replace the condenser
fi
lter, place the top of the
fi
lter in the guide and slide the
fi
lter up
un l the bo om of the
fi
lter clears the frame. Then push the bo om of
fi
lter into the guide
and let
fi
lter gently fall inside the guide.
NOTE: For e
ff
ec ve cooling clean the
fi
lter at least every 2 weeks.
– For your convenience, record the complete model number and product name (located on the
Product Iden
fi
ca on Plate), the purchase date, purchase loca on, serial number, and warranty
period in the table below.
– Also, a ach your purchase receipt as proof of purchase to this instruc on manual for future
reference.
– To ensure your product is covered by warranty, the complete faulty product along with your
original purchase receipt must be provided at the place of purchase.
Do not operate without the
fi
lter
fi
Ʃ
ed.
Do not operate the unit with a damaged cord or plug, a
Ō
er the unit malfunc-
Ɵ
ons, or if the unit has been dropped or damaged.
– Loosen up 2 bolts on
the front filter guard.
– Slide filter up and use
a vacuum cleaner to remove
the dust from the filter.
– Remove dust from the filter
using a vacuum cleaner
hose aachment.
– If required wash the filter in
lukewarm water with a mild
detergent. Leave to dry in
a shaded area before
reinstalling.
Figure 7 – Removing Filters
Figure 8 – Removal of Dust
