FXSO H.323 Gateway User Manual
Document Ver.: 2.1a
Release Sep., 2003
Copyright (c) 2002 Welltech Computer Co. Ltd.
67
usr/config$
Parameters Usage:
-print
print current h323 related settings
-mode
alternatives for gatekeeper or peer-to-peer mode
(0=gatekeeper mode; 1=peer-to-peer mode). If users select
gatekeeper mode, a valid gatekeeper is needed when
Gateway is in operation.
-----------------------------------------------------------------------------------------------
usr/config$ h323 –mode 1 (peer to peer mode)
-gk
to assign gatekeeper’s IP address when Gateway is in
gatekeeper mode.
-algk
assign second gatekeeper’s IP address as redundancy. If
Gateway fails to register to main GK for 10 time, it will try to
register to alternative GK.
-gwtype
gateway type has two kinds, gateway and terminal. Gateway
type – device will register as H.323 defined Gateway, user
has to define [prefix] in next command.
Terminal type – device will register as H.323 defined Terminal,
[prefix] command is not necessary.
-dfgw
default gateway is applied under
Peer-to-Peer mode
. User
defines a constant default gateway IP address, then any
number dialed if the number is not listed in phone book table
will pass forward to this IP Address.
-prefix
assign Gateway prefix number, as well as the registered
number on the Gatekeeper.
-line1
assign FXS TEL1 number.
-line2
assign FXO Line1 number.
-line3
assign FXS TEL2 number.
-line4
assign FXO Line2 number.
Note:
User can also set “x” in line number to disable the port. If the port is
disabled, it can only receive calls but not calling out.
