Wellsaw 1316S, Руководство по эксплуатации и техническому обслуживанию

Страница: 13 / 40

11
MACHINE OPERATION
1. Raise the frame and lock it into place by turning the manual flow control valve clockwise
(CW) until it stops.
2. Adjust material you plan to saw to the desired cut off length. Turn vise screw handle
clockwise (CW) to tighten. Always be sure the material is properly secure before cutting.
3. Push the blade START button to start the machine.
NOTE: If the coolant selector switch is in the ON position, the coolant pump will turn
on with the motor. Check to ensure there is adequate coolant in the coolant tank.
4. Adjust feed pressure for the material to be cut. Refer to pages 36 & 37 for the
recommended settings.
5. Open the manual flow control valve. Turn it counterclockwise (CCW) to the desired feed
rate.
NOTE: When breaking in a new blade, always reduce the frame feed rate to one half
(1/2) the normal rate of descent.
6. The saw will automatically shut off at the end of the cut. Raise the frame and lock it in to
place. Repeat the above operation for additional operations.
NOTE: The saw may be turned off at any time during the cutting operation by
pressing the STOP button on the operator control panel or by pressing the KILL
SWITCH (frame down limit switch) on the front of the machine.
One Year Limited Warranty
This Wellsaw is warranted against defects in material and workmanship installed or
performed at our factory. Within one year from the date of purchase, we will, free of
charge, at our option, either repair or replace any part of the Wellsaw which our
examination discloses to be defective because of workmanship or a defect in material, and to
make any necessary service adjustments as required. This warranty does not apply if the
Wellsaw has been subject to accident, alteration, abuse, misuse or which fails due to lack of
care or as the result of inadequate power supply and specifically does not apply to normal
wear of moving parts such as bearings, gears, pinion or blade. There is no warranties beyond
the description on the face hereof. Wellsaw shall not be liable for consequential or incidental
damage suffered or incurred with respect to defective material or workmanship.
All transportation costs or parts submitted to Wellsaw under this warranty must be paid by
the saw’s owner. No products or parts are to be returned to our factory without first
obtaining written permission.
NOTE: Be sure to fill out and return the Warranty Card provided with this Wellsaw.