Wells WV-4H Series, Руководство пользователя

Страница: 13 / 44

M504 p/n 2M-303903 Owners Manual WV
-4H V
entless Hotplate Cooktop
11
FILTERS INSTALLATION
1. FILTER PACK: Ships installed in the hood. If the FILTER PACK is
not in position, the
CHECK FILTERS
indicator will light.
If the FILTER PACK becomes clogged, the REPLACE FILTER
PACK
indicator will glow.
To install the FILTER PACK: Position the filter pack with the charcoal
portion UP. Slide the filter pack toward the rear of the unit until it
contacts the guides on the back panel. Push the filter pack UP into the
upper opening until it rests firmly against the filter pack seal. When up
in position, holder clips can be snapped over wall ledge on each side.
To remove FILTER PACK: Grasp both holder clips and pull INWARD
until the clips clear the sidewall ledge. Then, pull the filter pack down
and out.
2. PRE-FILTER: The PRE-FILTER ships in the FILTER FRAME. If the
PRE-FILTER is not in position, or if the PRE-FILTER is not in the
FILTER FRAME, the CHECK FILTERS indicator will light. If the PRE-
FILTER becomes clogged, the
REPLACE PRE-FILTER
indicator will
glow.
To install the PRE-FILTER: Pay attention to the air flow markings. The
AIR FLOW
arrow will point away from the installer. Slide the assembly
up into the front opening, behind the upper filter rail. While pressing
slightly against the bottom of the assembly, pull the FILTER HANDLE
toward you so as to engage the FILTER HOOK over the lip of the top
filter rail. Then lower and seat the assembly into the top indentation of
the lower filter rail.
3. GREASE BAFFLE: If the GREASE BAFFLE is not in place, the
CHECK FILTERS indicator will glow.
To install the GREASE BAFFLE: Slide the grease baffle up into the
indentation of the upper filter rail, then lower and seat it into the bottom
indentation of the lower filter rail. Pull toward you and downward to
verify the GREASE BAFFLE is properly seated in the lower frame rail.
NOTE:
The GREASE BAFFLE and
FILTER PACK activate
mechanical switches, and the
PRE-FILTER activates a
vacuum switch, to verify that
the filter elements are in their
proper positions.
All filter elements must be
properly installed or the
cooktop will not be energized.
Also, the
CHECK FILTERS
indicator will light.
IMPORTANT:
The filter hook prevents the
PRE-FILTER from being drawn
in during operation. After
installation, press against the top
of the filter frame to verify proper
engagement of the filter hook
over the lip of the top filter rail.
IMPORTANT:
Protect the surface of ceramic
cooktops from damage in the
event a filter is accidentally
dropped.
Use only genuine Wells parts and
filters, call (800) 264-7827 or your
authorized Wells service agent.
Parts supplied by others will void
your warranty and may not provide
safe operation.
INSTALLATION (continued)
Fig. 7 Filter Installation