NOTE:
DO NOT discard
the carton or other packing
materials until you have
inspected the appliance for
hidden damage and tested it
for proper operation.
Refer to
SHIPPING DAMAGE
CLAIM PROCEDURE
on
the inside front cover of this
manual.
WARNING:
RISk OF INjURY
Installation procedures must
be performed by a qualified
technician with full knowledge
of all applicable electrical and
plumbing codes. Failure can
result in personal injury and
property damage.
CAUTION
FIRE HAzARD
Avoid storing flammable or
combustible materials in, on
or near the appliance.
CAUTION
SHOCk HAzARD
The ground prong of the
electrical cord is part of a
system designed to protect
you from electrical shock. In
the event of internal damage
to the warmer. NEVER CUT
OFF THE GROUND PRONG
(large round prong). NEVER
TWIST AND ELECTRICAL
PRONG TO FIT AN EXISTING
RECEPTACLE.
Install an electrical circuit
and/or receptacle appropriate
to the voltage/amperage
requirements of the appliance.
IMPORTANT:
Damage due
to being plugged into wrong
voltage is NOT covered by
warranty.
INSTALLATION
4
UNPACkING & INSPECTION
Carefully remove the appliance from the carton. Remove all protective
plastic film, packing materials and accessories from the Appliance
before connecting electrical power or otherwise performing any
installation procedure.
Carefully read all instructions in this manual packed with the appliance
before starting any installation.
Read and understand all labels and diagrams attached to the
appliance.
Carefully account for all components and accessories before discarding
packing materials. Store all accessories in a convenient place for later
use.
SET-UP NOTES
1. Setup the appliance only on a firm, level, non-combustible
surface. Verify local codes for requirements. Concrete, tile,
terrazzo or metal surfaces are recommended. Metal over
combustible material may not meet code for non-combustible
surfaces.
2. Install one adjustable leg at each corner of the fryer by
screwing the leg into the fitting on the bottom. With a spirit
level, check that the appliance is level front-to-back and
side-to-side. Verify that the unit sits firmly ON ALL FOUR LEGS.
3. The lower portions of the legs are adjustable by turning; adjust
as required to level the appliance. All four legs must be adjusted
to firmly contact the counter in order to prevent tipping.
4. Avoid storing flammable or combustible materials in, on or near
the appliance.
ELECTRICAL HOOk-UP
1. Refer to the nameplate. Verify the electrical service power.
Voltage and phase must match the nameplate specifications.
Plugging the warmer into the wrong voltage can severely
damage the unit or cause noticeable decreased performance.
2. Your warmers is equipped with a grounded electrical cord.
This cord must be plugging into a properly grounded electrical
receptacle.
001 p/n 2M-303305 Owners Manual CT W
armers / Thermostat Control
001 p/n 2M-303305 Owners Manual CT W
armers / Thermostat Control
