4-2-2 Water flushing valve installation
Rubber
washer
Connection
bolt&nut
Solid
washer
1) Unscrew the connection lock nut from
the conection bolt and unscrew round lock
nut from water outlet valve respectively.
2) Insert the water outlet valve with seal
washer into the outlet part of Tank. After
adjusting the valve to its right place, screw
the round lock nut and tighten it.
3) Nest the rubber washer into the round
lock nut and bolt water in the connection
bolt respectively. Fix the tank with valve
installed to the closet with connection bolt
and connection lock nut tightly.
4-2-3 Top push button installation
4-3 Install the Toilet set.
1) Unscrew the lock nut from push button.
2) Insert the push buttom into the hole of tank cover, and screw the lock nut into the
thread of push button from the inner side of tank cover. (But keep it loose)
3) Measuer the lehgth of A1,A2 as picture, cut off the poles according to A3(A3=A1-
A2+1CM), screw poles into button holes and adjust it by screw in or out.
4) Look at above picture. The one with circle marker is 6L botton, and the other with semi-
circle marker is 3L botton.
Tank
Cover
Poles
Lock Nut
6L
3L
6L
3L
4-3-1 Place the cistern on the top of the
pan.
Small Rubber gasket
Rubber Water seal
Plastic screw
Plastic washer
Nut
4-3-2 Put the rubber water seal onto the
Cistern flushing outlet. Screw the bolt to
link the cistern onto the WC pan. Install
the plastic washer and the then tighten the
nut, entill the cistern steadly installed onto
the pan.
