6-8
WP 65
4.2
Technical data
Temperature range
100°C - 450°C (212°F - 850°F)
Tool cable
Silicone rubber, heat resistant
Heating element
Integrated heating wire element
Temperature sensor
Platinum sensor
Heating output
65 W
Voltage (heater)
24 V
Heat-up time
(approx.) 7s (50°C to 380°C)
(120°F to 660°F)
Connection
6 pin connector, polarity protected with lock
Weight
30 g incl. cordless tip
Tip type
Supply unit
XNT series
Weller stations
5
Commissioning the device
WARNING!
Risk of burns
The soldering tips of soldering irons become very hot during
soldering and desoldering processes.
There is a risk of burns from touching the tips.
Z
Do not touch the hot soldering tips and keep them away from
inflammable objects.
1. Carefully unpack the WP 65 soldering iron.
2. Place the soldering iron into
safety rest WDH 10
.
3.
Insert the connecting plug (5) into the power supply socket and
lock it by turning it clockwise.
4. Check to make sure that the mains voltage matches the voltage
specified on the rating plate of the supply unit.
5. Switch on the supply unit and set the required temperature.
6. If the tool has not reached the required temperature. Wet the
soldering tip with solder.
6
Replacing the WP 65 soldering tips
WARNING!
Risk of burns
The soldering tip becomes hot during soldering and desoldering
processes.
There is a risk of burns from touching the soldering tip.
Z
The soldering tool must be switched off and stand at least
3 min. in the safety rest (WDH 10) until the soldering tip has
cooled off. Only replace the soldering tips when they are cold.
PK Elektronik Vertriebs GmbH, E-Mail: [email protected], Internet: www.pkelektronik.com
