welldana 61-091001, Руководство пользователя

Страница: 2 / 13

Preparation Before Installation
1.
Before installation, please get ready for the water supply, power supply and the drainage pipe in the
installation position according to the water and electrical installation diagrams. The water pressure shall be
0.2 - 0.6Mpa; and the water supply shall apply to G1/2" hose screw connection for cool and warm water. The
diameter of the drainage pipe shall be 1 1/2" (40mm). As to the electric data, please refer to the electrical
parameter’s nameplate on the product.
2.
Prepare following tools before installation: Cross screwdriver, Straight screwdriver, Level and Spanner.
Safety Precaution
1. Please note that this bathtub is only for indoor installation.
2. The product may not be used by children, the sick and lack of the experience. Children can use under the
supervision of the parents.
3.
The earthing device must be permanently connected to the fixed-line.
4. lf there are some electric products around bathtub (such as hair dryer, etc.), please fix them well to avoid
falling into the bathtub.
5.
Ensure that the installation in the correct area and long-term stable work.
6. Ensure that the Leakage protector (RCD) must be included in the fixed wiring according to wiring rules.
7. For your health and long-term use of the product, please use new plumbing to connect the device, the old
hose will not re-use.
8.
lf the wire is damaged, it must be replaced by the manufacturer, service agent or the qualified personnel
in order to avoid danger.
Maintenance Instruction
1. Maintenance of the chrome hardware: Lightly clean the hardware with soft cloth each week, do not use
coarse cloth.
2.
Do not place the product in insolation or freezing cold.
3. Clean the product with soft cloth soaked with cleaning agent. Do not soak with acetone, ammonia, or
organic solvent cleaning agent. If disinfection needed, do not use formate and formaldehyde to protect the
acrylic part.
4.
Maintenance of the tub: If any scar in the bathtub, polish with No.2000 water sandpaper, then renew it
with toothpaste and soft cloth
Sharp hard objects impact is prohibited.
Installation Procedures
The product of all components are standard parts. Installation, please refer to the product water and electrical
installation diagrams and the electrical parameters nameplate.
1. Confirm the installation position
Place the bathtub in the installation position, adjust the level of the bottom of the nut to enable the bathtub to
remain horizontal. (Refer to the below diagram)
2. Drainage connection
Put the 1 1/2"drainage hose, which in the bottom of the bathtub, into the drainage hole in the ground or in the
wall, then fix it with water-proof tapes or silica gel. Please don't bend or cross the hose in order to avoid
affecting the drainage effect. (Refer to the below diagram)