10
2.5.2. Program overview
If you want to review the settings for either the
factory program and/or your customized program,
you may do so by pressing the
PROGRAM
/
REVIEW
button for 1 second. By pushing this
button repeatedly you can review the complete
program.
If you press the
PROGRAM/REVIEW
button for 4
sec. then you enter the programming process.
Press the
SET/RETURN
button should you hold the
PROGRAM/REVIEW
button too long.
DOWN
FAN
TIME
TIMER
FLAME
BACK
SET
RETURN
PROGRAM
REVIEW
AHEAD
-
+
MODE
UP
2.5.3. Program cancellation – return to factory settings
To cancel the customized program that you have entered and to return to the factory settings:
Press
SET/RETURN
to make sure the LCD-screen is in its normal state. Press and hold
PROGRAM/REVIEW
and at the
same time, press
SET/RETURN
for a period of ± 10 sec. The customized program will be cancelled when the display
icons/numbers flash with some icons disappearing. The LCD-screen will begin flashing
PROGRAM FOR
,
START AT
,
together with the digits in the TIME and SET frames. This confirms that the CUSTOMIZED program has been cancelled.
Press
SET/RETURN
to return the LCD-screen to normal state, or wait approximately 10 seconds and the LCD-screen will
return to its normal state automatically.
2.6. Operating your appliance
2.6.1.
Manual (ON/OFF)
Press
MODE
until the LCD-screen displays
ON.
Together with
ON
the LCD-screen will display
FLAME
and
1 flame
symbol
. At this point the spark electrode will begin sparking to ignite the pilot for a period of approx. 60 seconds. As soon
as a flame is detected the sparking will stop, and after a few seconds the main burner will ignite. The flame height at this
stage will be
LO
. The appliance will burn as long as it is not turned off manually, regardless of the room temperature.
REMARK
: In case of a new installation, it is possible that the pilot does not ignite after 60 seconds, due to air in the gas
pipes. In this case the appliance will shut down and turn to secure mode. Before you can use the appliance again it has to
be reset. To reset the appliance press
MODE
till LCD-screen displays
OFF
. To ignite again: press
MODE
until LCD-screen
displays
ON
. Repeat this procedure until there is no more air in the gas pipes that lead to the appliance and the pilot ignites.
Once the pilot is on and the main burner is burning low, it is possible to change the flame height and the speed of the fan
with the
FLAME
and
FAN
toggle keys.
To switch off the device, push MODE until OFF appears. The pilot as well as the main burner will be quenched.
After this, the fan will still turn for about 15 minutes, until the remaining heat is fully utilized.
There is an additional safety imbedded in this mode of operation that will put the fire automatically to OFF after a period of
9 hours.
*only for devices equipped with a fan
