Welker APP-5, Руководство пользователя

Страница: 6 / 10

I
NSTALLATION
& O
PERATIONS
IOM-104 Page 6 of 10
APP-5
Rev: B
Last updated: 9/8/2009
2. INSTALLATION & OPERATION INSTRUCTIONS
2.1 G
ENERAL
After unpacking the unit, check it for compliance and for any damages that may have
occurred during shipment.
Claims for damages caused during shipping must be initiated by the receiver and
directed to the shipping carrier. Welker is not responsible for any damages caused from
mishandling by the shipping company.
When sealing fittings with PTFE tape, refer to the proper sealing instructions for the tape
used.
Recommended Tools
It would be advisable to have the following tools available
for installation of the unit; however, tools used will vary
depending on model.
•
Measuring tape
•
6" adjustable wrench
•
10" adjustable wrench
•
Permanent marker
•
Tubing cutters
•
Fine-grit sandpaper
•
Small file
2.2 P
REPARING THE
P
ROBE FOR
I
NSTALLATION
1. Determining the insertion length
Before installing the unit, determine the length the insertion shaft will need to travel
inside the pipeline. Measure from the top of the pipeline’s isolation valve to the center
one-third of the pipeline.
2. Setting the insertion length on the shaft
Once the insertion length of the shaft is determined, this length should be measured on
the shaft itself (Refer to Figure 2 following steps 2a-2e on the next page.)