Weldclass WC-210MST, Руководство по эксплуатации

Страница: 25 / 84

Weldforce 210
MST
& 250
MST
© Weldclass 2020 | E.&O.E. 25
5 POWER SUPPLY
5.1 Electrical Connection
5.1.1 Weldforce 210MST
The Weldforce 210MST is factory-fitted with a 10A 240V plug for commissioning purposes. Whilst this
10A plug is fitted the operator must ensure that the machine is set on 10A mode
and ensure that output
& duty cycle limits indicated in Table 3 are not exceeded.
If full output is required (as per Table 2 ), 15A power supply mode can be selected, to allow use on 15A
240V power supply. If used on 15A power supply, the machine should be fitted with a 15A 240V plug.
Follow the procedure below for setting machine to 10A or 15A Output Mode;
5.1.1.1 Setting machine to 10A or 15A Input Mode
1. Ensure machine is in MIG mode (SYN or MAN - refer to 4.1)
2. Press and hold both the ‘Top Selection Knob’ (21) and the ‘Bottom Selection Knob’ (22)
together for 3 seconds until the Menu number is displayed on the screen.
3. Rotate the ‘Bottom Selection Knob’ (22) until Menu #5 [PLG] is displayed.
4. Press the ‘Bottom Selection Knob’ (22). The ‘PLG’ Function Indicator should flash.
5. Rotate the ‘Bottom Selection Knob’ (22) to choose 10A or 15A Mode.
6. Press the ‘Bottom Selection Knob’ (22) to confirm the setting.
5.1.2 Weldforce 250MST
The Weldforce 250MST is factory-fitted with a 15A 240V plug for commissioning purposes. Whilst this
15A plug is fitted the operator must ensure that the operation of the machine does not exceed the
output and duty cycle limits as per
Table 5 .
If full output is required (as per Table 6 ), machine must be connected to a 20A 240V power supply and
the machine should be fitted with a 20A 240V plug.
WARNING! These machines must be electrically connected by a qualified electrical
trades-person. Personal injury or death or damage to the machine may result from
incorrectly connected power supply or plug.
5.2 Extension Leads
If an extension cord must be used, it should be minimum cable core size 2.5mm
2
.
Using extension leads of over 30m is not recommended.