Weldclass Platinum PP365, Руководство пользователя

Страница: 9 / 12

User Manual
9
Wire Feed Set Up
Setup the wire in the power source feed unit ready to be fed through
the torch. If the wire has a strong cast, feeding can be improved by
adding a slight bend in the end of the wire to straighten it, before clamping in the
feed rolls.
To feed the wire through the torch;
• Turn on the power source.
• Press the torch trigger. This should start the power source feed unit drive and
the torch feed unit drive simultaneously.
• The wire will fed up through the torch. Use the speed control of the power
source wire feed unit to vary the wire feed speed, slowing the wire as it reaches
the end of the torch.
• As the wire feeds into the torch feed unit have the rolls in the open position by
pulling on the roll pressure release lever, which should be adjusted to a low
pressure load.
• When the wire passes between the rolls release the trigger to stop the drive.
• Release the lever to close the rolls together. You may need to push the wire
• Operate the torch trigger again to fed the wire into the neck guide and through
the neck.
• When the wire is visible from the end of the contact tip release the trigger to
stop the wire feeding.