WEISS MAN301, Руководство по эксплуатации, Страница: 24 / 208

Usually you do not need to change anything on this page. The
Wireless Uplink is disabled in Configuration 2, it can not be en-
abled.
Here are the details to this page:
1. The „Wireless Uplink” entries are explained in the sections
where the Configurations with Uplink enabled are described.
2. The „Access Point” entries show the SSID and password of
the MAN301 access point. Both SSID and password can be
changed if preferred.
3. The „Ethernet IP address” shows the IP address the MAN301
has got from the DHCP server, i.e. typically this is the router it
is connected to.
4. The „factory reset” resets all network settings to the original
settings when the MAN301 left the factory.
•
The next entry in the Server Preferences is the
„Audio De-
vices”
pad. Tapping on it reveals a screen similar to this:
Here the firmware of the audio device can be updated. „Audio de-
vice“ means the currently active audio interface for playback
from the MAN301. This normally is the audio interface internal
to the MAN301 with its AES/EBU and S/PDIF and (optionally)
analog connections. But it could also be e.g. a Weiss DAC202 D/
A converter connected to the MAN301 via Firewire. This DAC202
would show up in the window above and could thus be updated
with new firmware via the MAN301. The window „Latest Re-
lease“ on the right hand side above reflects the currently avail-
able firmware on our web server. I.e. the MAN301 has to be con-
nected to the Internet to be able to fetch the firmware. With the
release of a new MAN301 base station software, any possible
change in the firmware for the MAN301 internal audio device will
23