OPERATING INSTRUCTIONS FOR THE INT202 FIREWIRE INTERFACE
Page
20
Date: 03/10
Sampling Rate:
The sampling rate of the device when
internally clocked.
Buffer Size:
Larger buffer sizes increase robustness
against dropouts, lower buffer sizes provide low latency.
Operation Mode:
determines the stability of the system.
Try other modes if there are clicks in the music.
Global Settings / WDM: Enables the WDM driver.
Global Settings / DPC: Determines your computers
performance and recommends a operation mode.
Global Settings / System: Some utilities to determine the
chipset in your computer and to get information on the
sup-ported chipset. Required for debugging if prob-lems
with the Firewire connection are encoun-tered.
Global Settings / Info: Information about the driver
version.
Mac OSX:
Configure the INT202 via the “Audio MIDI Setup”
(Applications > Utilities) and the “WeissFirewire Control
Panel” (Applications).
Device Settings / General: The device settings should be
pretty self explana-tory.
Device Settings / Firmware Loader: Allows to upload new
firmware to the INT202. Not used for normal operation.
Global Settings / Bus:
Master:
Is the device which is sync master on the virtual
bus in case multiple devices (“INT202s”) are connected.
Sync Source:
The clock to which the INT202 should sync
to. Usually this is the INT202’s internal clock generator.
Sampling Rate:
The sampling rate of the device when
internally clocked.
Operation Mode:
determines the stability of the system.
Try other modes if there are clicks in the music.
Global Settings / Info: Information about the driver
version.
