background image

 

 
 
 
 
 
 
 
 

Installation and Startup Guide

 

This document covers the installation of MT607/610i Series, for the detailed specifications and operation, 
please refer to Datasheet and relevant User Manual. 

Install Environment: 

NEMA Rating

 

MT607/610i

 is NEMA 4X rated.

 

Electrical 
Environment

 

MT607/610i

 has been tested to conform to European CE requirements. This 

means that the circuitry is designed to resist the effects of electrical noise. This 
does not guarantee noise immunity in severe cases. Proper wire routing and 
grounding will insure proper operation.

 

Environmental 
Considerations

 

(1)  Make sure that the displays are installed correctly and that the operating 

limits are followed. Avoid installing units in environments where severe 
mechanical vibration or shocks are present. 

(2) 

Do not operate the unit in areas subject to explosion hazards due to 
flammable gases, vapors or dusts.

 

(3)  Do not install the unit where acid gas, such as SO2 exists. 

(4) 

This device should be mounted in the vertical position and for use on the flat 
surface enclosure.

 

(5) 

Conform to UL508 (ISBN 0-7629-0404-6) machine safety for use in 
Pollution Degree 2 Environment.

 

 

Unpacking the Unit

 

Unpack and check the delivery. If damage is found,   
notify the supplier.   

Installation Instructions 

Secure the operator panel in position, using all the fastening holes and the provided brackets   
and screws: 
 

 

 

 

Type A(mm)

B(mm)

MT607i 192  138 

MT610i 260  202 

 

 

Power Connections 

 

 

 

 

 

 

 

System Settings 

Power up HMI, click CECP to do touch screen calibration, backlight adjustment, or screen rotation.

 

 
 
 
 
 

 

 

 

 

MT607i  MT610i

 

 

Installation Instruction

NOTE:  

Place the operator panel on a stable 
surface during installation. Dropping it or 
letting it fall may cause damage. 

3

(1) Installation Instruction, 2-sided A4 *1

(2) Human Machine Interface *1

(3) Power Connector *1

(4) Brackets & Screws V2.1 *1 pack

 

(5) Fuse 1.25A/250V 5*20mm *1

5

4

NOTE:  

1. 

Connect positive DC line to the ‘+’ terminal 

and the DC ground to the ‘-' terminal. 

 

2. Please do not connect HMI with PLC and PC 
simultaneously to prevent potential difference 
from destroying USB ports of HMI and PC. 
 
To make a connection, strip about 3/8” of 
insulation off the end of the wire, turn the 
connector screw counterclockwise until the gap 
is wide open, insert the wire all the way in, and 
turn the screw clockwise until it’s tight. 

(A)

(B) 

Cutout 

(1) 

 

(2) 

 

 

 
(5) 
(4) 

(3) 

( Note 1: For the details of HMI 
DIP SW function settings please 
refer to Part 8 in this guide. )

 

Отзывы: