6
2.3.5 Dip Switch
Touch Screen Calibrate mode: In this mode when you power on the MT600, the screen will display a
“+” sign at the center of the screen. Use a stylus or finger to push the center of the “+” until it moves.
The “+” moves to upper-left, lower-left, lower-right and upper-right corners. When all five “+” are
done the “+” will disappear. The Touch Screen parameter will store at Flash Rom.
Boot Loader mode: Load new Windows CE image file.
If the MT600 already load the CE image with boot loader. Set the DIP SW2 ON then power ON into
boot loader mode. Refer the load Win CE image document.
2.4 CE Requirements
EU directives that apply to the MT-600 Series:
EMC Directive (89/336/EEC, 92/31/EEC, 93/68/EEC) electromagnetic emissions and immunity
Machinery Directive (89/392/EEC, 91/368/EEC, 93/44/EEC, 93/ 68/EEC) machine safety
MT500 products will be CE-marked to indicate compliance with the EMC Directive.
The MT-600 Series has been designed to operate satisfactorily in electromagnetic noise (immunity) and
without emitting high levels of electrical noise into the environment (emission). The units are designed to
meet European Community standards when installed per the wiring instructions in this manual.
Compatibility
Standards
The MT-600 has been designed to meet electromagnetic compatibility for industrial
environments.
• CISPR (EN 55011) Group 1, Class A Radiated Emissions levels
• EN50081-2 Generic emission standard, industrial environment (Also US FCC
Class A)
• EN50082-2 Generic immunity standard, industrial environment
SW1 SW2 Mode
ON
OFF Touch Screen Calibrate mode
OFF ON Boot Loader mode
OFF OFF Normal
