BiConnect BiRec Ma + MA-K
Version 2
2016-04-20
Assembly and installation instructions/ Instructions de montage et d’installation
Item number/
We reserve the right to make technical changes/ Sous reserve de modifications techniques Numéro d’article 117476-0000 Page 10/28
6
Programming
6.1 Programming the remote receiver
The system is usually supplied pre-programmed. This means that, when the system is
delivered, all the components can be controlled using the hand transmitter supplied. On
rare occasions or if servicing has been carried out, however, the system will need to be
programmed on site. This is done by pairing up the hand transmitter and remote receiver
and setting them to various functions.
6.2 Program the awning
1.
Connect all receivers that have not yet been connected to an electricity supply (electrically
installed). In the case of receivers that have already been electrically installed, briefly
disconnect the power supply immediately before programming.
2.
Start programming mode: within 5 minutes of disconnecting the power supply, hold down the
LEARN key
(1)
on the hand transmitter for 2 seconds. The remote receiver then enters
programming mode for about 2 minutes. During this time, the awning moves up for 4
seconds and then down for 4 seconds.
3. On the hand transmitter, select the channel you want to use to program the awning (e.g.
Channel 1).
4. Immediately after the awning starts moving up (within the first second), press the
UP
key on the hand transmitter. The receiver confirms the command by briefly stopping the
awning and then moving it up further. If the receiver does not confirm the command, simply
repeat this step on one of the next cycles.
5. Immediately after the awning starts moving down (within the first second), press
the
DOWN key on the hand transmitter. The receiver confirms this step by leaving programming
mode; the sun protection stops moving.
Finally, check that the awning has been successfully programmed.
If the awning cannot be operated after the programming process, the hand transmitter is possibly
still in learning mode (transmission control LED fast flashing orange). Terminate the
programming process by pressing the STOP button for 6 seconds. Afterwards it should be
possible to operate the awning. Otherwise the programming process must be repeated as
described.
1
