Initial commissioning procedure
42
1168670000/02/08.11
3.5
Positioning the label sensor
Figure 4
Positioning the label sensor
A
Label sensor
B
Cover over the label sensor
C
Labels
D
Label spacing
1
Unlatch the print head module and raise it up.
2
Remove the cover (B) from the label sensor (A).
3
Position the label sensor (A) so that the centres of the labels pass over it – thus allowing the sensor to de-
tect both the label and the spacing between the labels.
Refer to both examples in the accompanying illustration.
4
Replace the cover over the label sensor.
5
Push down on the print head module until it snaps back in.
