20
48. Slide a Pad Tube (28) through the hole in the Leg
Lever (29). Press two 19mm Round Inner Caps
(34) into the ends of the Pad Tube. Slide two
Foam Pads (30) onto the Pad Tube.
Repeat this step with the other Pad Tube (28)
and the Seat Frame (36).
Orient the Eyebolt (109) as shown. Attach the
Eyebolt to the Leg Lever (29) with an M10 Nylon
Locknut (21) and an M10 Washer (9). Note: Make
sure that Eyebolt is positioned vertically on the
Leg Lever.
50. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENTS, beginning on the following page.
Before using the weight system, pull each cable a few times to make sure that the cables move smoothly
over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If
the cables are not properly installed, they may be damaged when heavy weight is used. See the
CABLE DIAGRAMS on page 25 for proper cable routing. If there is any slack in the cables, you will
need to remove it by tightening the cables; see TROUBLESHOOTING AND MAINTENANCE on page 24.
49. Attach the Curl Pad (24) to the Curl Post (35) with
two M6 x 16mm Bolts (18).
48
49
34
34
30
30
28
29
36
28
24
35
18
9
9.
Lubricate the M10 x 98mm Bolt (16) with grease.
Attach the Press Frame (17) to the Base (4) with
the Bolt and an M10 Nylon Locknut (21). Do not
overtighten the Locknut; the Press Frame
must be able to pivot easily.
9
4
21
16
Lubricate
17
7.
Press four 40mm x 60mm Inner Caps (27) into
the ends of the Top Frame (55).
8.
Hold the Top Frame (55) on top of the Front
Upright (42) and between the Weight Guides (62).
Attach the Top Frame to the Front Upright with
two M10 x 60mm Bolts (7), two M10 Washers (9),
and two M10 Nylon Locknuts (21). Do not tight-
en the Locknuts yet.
Attach the Weight Guides (62) to the indicated
tube on the Top Frame (55) with an M10 x
155mm Bolt (60), two M10 Washers (9), and an
M10 Nylon Locknut (21).
7
8
27
55
62
42
Tube
21
21
60
9
7
9
55
27
27
27
10. Press a 50mm Square Inner Cap (44) into the top
of a Press Arm (46). Attach the Press Arm to the
Press Frame (17) with two M10 x 70mm Bolts
(22) and two M10 Nylon Locknuts (21).
Repeat this step with the other Press Arm
(46).
10
46
46
44
17
22
21
9
Arm Assembly
109
21
9
