7
3. Orient the Folding Lever (6) as shown, and
insert it into the lower bracket on the Crossbar
(5).
Attach the Folding Lever (6) to the Crossbar (5)
with an M8 x 60mm Bolt (35) and an M8
Locknut (32).
Do not overtighten the Locknut;
the Folding Lever should pivot freely.
Then, attach the Folding Lever (6) and the
Spring (17) with an M8 x 45mm Bolt (43), an
M8 Washer (30), and an M8 Locknut (32).
Tighten the Locknut until three threads of
the Bolt are below the Locknut.
3
4. Attach the Main Frame (7) to the Crossbar (5)
with an M16 x 120mm Bolt (40) and an M16
Locknut (42).
Do not overtighten the Locknut;
the Main Frame should pivot freely.
Attach the tether on the Pin (22) to the
Crossbar (5) with an M4 x 16mm Screw (37).
Then, insert the Pin (22) through the Crossbar
(5) and the Main Frame (7).
See steps 1 and 2.
Tighten the M10 Locknuts
(38) and the M8 Locknuts (32).
4
5. Orient the Leg Lever (11) and the Weight Tube
(12) as shown.
Attach the Weight Tube (12) to the Leg Lever
(11) with an M8 x 55mm Bolt (31), two M8
Washers (30), a Weight Tube Bushing (29), and
an M8 Locknut (32).
Press the Bumper (25) onto the end of the
Weight Tube (12).
Apply some of the included grease to an M10 x
70mm Bolt (36).
Attach the Leg Lever (11) to the Front Leg (10)
with the M10 x 70mm Bolt (36) and an M10
Locknut (38).
Do not overtighten the Locknut;
the Leg Lever must pivot easily.
5
43
32
6
17
30
32 35
5
7
40
5
32 30
29
38
36
25
Grease
30
31
12
11
10
42
22
37
