16
27. Wrap the Cable (66) around a Small Pulley (59).
Attach the Small Pulley, a Guard (61), a Cable
Trap (76), and an M10 Washer (96) to the left
Adjustable Pulley Plate (67) with an M10 x 50mm
Bolt (111) and an M10 Nylon Locknut (94).
28. Wrap the Cable (66) around a Small Pulley (59).
Attach the Small Pulley, two Guards (61), a Cable
Trap (76), and an M10 Washer (96) to the Center
Frame (51) with an M10 x 95mm Bolt (114), an
M10 Washer, and an M10 Nylon Locknut (94).
27
28
94
96
76
61
111
59
66
67
61
61
76
59
51
94
114
96
66
96
26.
See the CABLE DIAGRAM on page 28 as you
identify and assemble the cables.
Locate the Butterfly Cable (66).
Attach the
Cable to the Center Frame (51) with an M10 x
20mm Bolt (110) and an M10 Nylon Locknut (94).
Make sure the flat edge of the Cable is against
the Center Frame.
26
94
51
66 110
25. Attach a VKR Handle (53) to the VKR Arm (52)
with an M10 x 60mm Button Bolt (126), an M10
Washer (96), and a VKR Cap (83).
Attach the other VKR Handle (53) to the VKR
Arm (52) in the same way.
Apply grease to an M10 x 150mm Bolt (127).
Attach the VKR Arm (52) to the Center Upright
(29) with the Bolt and an M10 Nylon Locknut (94).
Do not overtighten the Nylon Locknut; the
VKR Arm must pivot easily.
Then, insert the
Long Pin (77) into the VKR Arm. Attach the tether
on the Long Pin to the VKR Arm with an M4 x
16mm Self-tapping Screw (102).
25
29
52
94
127
Grease
102
126
77
53
53
83
96
