WEG MVW3000 Series, Руководство по программированию

Страница: 187 / 264

5
DETAILED PARAMETER DESCRIPTION
P1724 - Bypass of the cell W1
P1725 - Bypass of the cell W2
P1726 - Bypass of the cell W3
P1727 - Bypass of the cell W4
P1728 - Bypass of the cell W5
P1729 - Bypass of the cell W6
P1730 - Bypass of the cell W7
P1731 - Bypass of the cell W8
P1732 - Bypass of the cell W9
P1733 - Bypass of the cell W10
P1734 - Bypass of the cell W11
P1735 - Bypass of the cell W12
Adjustable range: 0 to 4 Factory setting: 0
Acesso: Menu
→
Configurations
→
Functions
→
Bypass
Description:
It defines whether the respective cell should be removed from the system (option > 0).
The option 1 should be used when the corresponding cell is replaced by a mechanical bypass cell.
Option 2 must be used to manually actuate the automatic bypass relay of the cell.
Option 3 is read-only. Indicates that the respective cell was automatically removed from operation due to a
manageable fault.
Option 4 is read-only. Indicates that the respective cell was automatically removed from operation, because it
was linked in parallel (P1892) with another cell that was bypassed.
Once the parameter is set to 1, 2, 3 or 4, the respective cell can operate again as soon as the user resets the
parameter to 0 (Disable).
Refer to P1500 (Automatic Bypass).
WARNING!
Option 1 must be used after the user has physically verified that the cell in question is assembled in
the set and that it has the bypass system.
Table 5.79: Bypass of the cell W12
P1735 Function
0 Disable
1
Mechanical bypass cell
2
Manual activation of the bypass relay
3
Automatic bypass after a manageable fault
4
Automatic bypass by parallel association
✓
NOTE!
This parameter can be changed only with the motor stopped.
P1739 - RL8 Function MVC3
Adjustable range: 0 to 2 Factory setting: 0
Acesso: Menu
→
Configurations
→
I/O
→
Digital outputs
Description:
Digital output state can be monitored on parameter P0071.
MVW3000 | 5-111