WEG 14105364, Руководство пользователя

Страница: 20 / 94

14 | ADW300
E
ng
lis
h
Installation and Connection
3.2.6 Control Connections
The control connections must be made in accordance with the specification of the "CONTROL"
connector of the ADW300. Functions and typical connections are presented in
Figure 3.4 on
page 14 . For further details on the specifications of the connector signals, refer to Chapter
7 TECHNICAL SPECIFICATIONS on page 25 .
NOTE!
For the configuration of the digital inputs, refer to the programming manual,
available for download on website:
www.weg.net
.
Connection to the
conveyor belt panel
Control Connector Description
1 DI1 Safety switch
2 DI2 Decelerates E.P./ Stop
3 DI3 Stop
4 DI4 Start/Accelerate E.P.
5 GND Reference 0 V
6 AI1 +5 Vdc power supply (Capacity: 50 mA)
a) Connections for operation via Electronic Potentiometer (E.P.)
Control Connector Description
1 DI1 Frequency input (14 Hz a 200 Hz)
2 DI2 NC
3 DI3 NC
4 DI4 NC
5 GND Reference 0 V
6 AI1 +5 Vdc power supply (Capacity: 50 mA)
Configuration in
open collector
Connection to the
conveyor belt panel
b) Connections for operation via Frequency Signal (FI) or via Serial (RS600 Panel)
Figure 3.4: (a) and (b) signals control card connector
For the correct connection of the control, use:
1. Conector Molex 6 vias 5102 com terminais Molex 5103. Utilizar cabos com bitola de 0,2 mm².
2. Wiring of the connector of the control board with shielded cable and separated from the other
wiring (power, command in 110 V / 220 Vac, etc.). If those cables must cross other cables,
it must be done in perpendicularly among them, keeping the minimum separation distance
of 5 cm (1.97 in) at the crossing point.