`çãéäÉíÉ=háí==j^k=
`çãéäÉíáçå=çÑ=~ëëÉãÄäó=Öêçìéë
1580
2
13
5
58
2
391
2
60
62
61
63
59
708
503
503
5
359
54
64
49
48
54
54
503
49
NN
aêáîÉ=ëÉÅíáçå=
11.1 Mounting the motor and gearbox
Use screws 2 to bolt the gear cover 59 to the motor 708 (we supply
the white motor pinion 60 (14t.) already mounted to the motor shaft).
Before assembling the gearing lubricate the gears and shafts lightly
with Vaseline. Then clip the joint ball 64 in the gear wheel 62. Lay this
gear wheel, the double pinion 61 with shaft 63 and -not to forget!- the
shim 391 in the gear housing 58 and use screws 2 and M3 nuts to
secure the gear housing to the cover. Once assembled, this unit is
inserted from above into the opening in the frame and secured at the
sides with screws 2, washers 13 and M3 nuts. At the same time the
drive shaft 359 is inserted at the joint balls between the gearbox and
the differential.
11.2 Mounting the tank and speed controller
When affixing the tank please ensure that the ribbon cable with the
two lamp PCBs are located between the frame and the screws
used to affix the tank (ill. 6).
Press the tank cap 49 into the tank tube 48. Now attach the tank and
the speed controller 1580 to the frame. The insulation strips 503 must
be wrapped around these two components in such a way that the re-
inforcement, about 20 mm long, is located between the tank tube and
the frame and that no contact with other components is possible.
First use a screw 5 and an M3 nut to attach the straight ends of the
clamp fittings 54 to the top of the frame. Now pass the other end
around the tank or speed controller, clamping the insulating strips in
between, and slide the free end from below the frame onto the threads
of the screw 5. Now the tank and the speed controller are in contact
with the frame. The cable exit at the speed controller should point to
the front and toward the frame. The clamp fittings are secured from
below with M3 nuts.
NOTE: Instead of the tank, to the left frame side you perfectly may
add an Electronic Original Diesel Engine Sound, Art.-No. 189.
57-e.DOC / K-MAN
Page 8
Drive section ill. 11
Brake light
green/yellow
to the radio receiver
Reinforcement
to battery
B-44-11
Qty.
No. Assembly part
1
61 Double pinion
1
62 Gear wheel with joint
socket
1
63 Shaft for gear 116
1
64 Ball joint
1
359 Drive shaft 145mm
1
391 Shim 5 x 10 x 1
4
503 Insulating strip
1
708 Bühler motor incl.
14 teeth pinion
1
1580 Speed controller,
round tank short
Qty.
No. Assembly part
14
--- Nut M3
9
2 Screw M3 x 8
4
5 Screw M3 x 20
2
13 Washer 3.2
1
48 Tank tube, polished
2
49 Tank cap, flat
4
54 Clamp fitting, standard
frame
1
58 Case for gear 116
1
59 Cap for gear 116
(1)
60 Motor pinion white,
14teeth
