WELD THE WORLD
Cod. 006.0001.1940
15/02/2021 V.2.2
Discovery 162T
10
ENGLISH
L6
When this LED illuminates the following parameter can be set: DOWN SLOPE
L7
When this LED illuminates the following parameter can be set: FINAL CURRENT
L8
When this LED illuminates the following parameter can be set: POST GAS TIME
L12
Illumination shows that the following function has been activated: 2 stroke procedure.
L13
Illumination shows that the following function has been activated: 4 stroke procedure.
L14
SPOT
Illumination shows that the following function has been activated: 2 stroke pro high
frequency arc strike (HF).
A flashing signal means the following function has been activated: 2 stroke spot pro
high frequency arc strike (HF).
L15
Illumination shows that the following function has been activated: 4 stroke pro high
frequency arc strike (HF).
L9
This LED illuminates to show that the following welding mode is selected: MMA
L10
This LED illuminates to show that the following welding mode is selected: TIG DC CONTI
-
NUOUS
L11
SYN
This LED illuminates to show that the following welding mode is selected: PULSED DC TIG
A flashing signal means the following welding mode is selected: SYNERGIC PULSED DC TIG
D1
The display shows the value of the selected parameter.
S1
Menu
Menu
Menu
Menu
Press the button to select the parameter to be set.
Hold down the button for 3 seconds to gain access to the second level menu.
S2
This button selects the welding mode.
S3
This button selects the torch trigger procedure.
E1
The encoder sets the value of the selected parameter.
4 UNIT POWER-UP
Set the welding power source ON/OFF switch to “I” to switch on the unit.
FX.X The message appears on the following display:
D1.
x.x= software version
First power-up or power-ups following a RESET procedure
The welding power source sets up for welding with the factory preset values.
Subsequent power-ups
The welding power source sets up for welding in the latest stable welding configuration that was active
at the time of power-off.
