28
VEnTILATIon
m
wArnInG: Ventilation holes must be provided in the
structure at the top and bottom to provide ventilation in the
event of a gas leak.
Ventilation holes can be located in a low visibility area and should be protected by
screening material to prevent rodents and insects from entering the structure. Air holes
will also help dry moisture.
Note: These drawings are only a reference.
• Cross ventilation must be incorporated in the supporting structure. We recommend a
minimum of 100 square inches (254 square cm) of venting per side.
• Vents should be on two sides of the structure.
• The drawings are for reference only.
• Location of the vents should be from the center, outward.
• Locate the vents at both the bottom of the structure and at the top of the structure.
• The bottom vents should be as close to ground level as possible. Make sure the vent
area is not blocked by interior supports of the structure.
• We recommend vents with screens.
• Access doors to the structure are not considered vents.
• Clean the vents periodically.
bUILT-IN TANK eNcLoSURe ASSembLY VeNTILATIoN
m
dAnGEr
failure to follow recommended minimum venting
instructions can cause gas to collect in the structure in the
event of a gas leak. This may result in a fire or an explosion
which can cause serious bodily injury or death, and damage
to property.
◆
m
ATTEnTIon: This product has been safety tested and is only certified for use in a specific country. refer to country
designation located on outer carton.
These parts may be gas carrying or gas burning components. Please contact Weber-Stephen Products LLC Customer Service
Department for genuine Weber-Stephen Products LLC replacement part(s) information.
m
wArnInG: do not attempt to make any repair to gas carrying, gas burning, igniter components or structural components
without contacting weber-stephen Products LLC Customer service department. Your actions, if you fail to follow this
Product warning, may cause a fire, an explosion, or structural failure resulting in serious personal injury or death as well as
damage to property.
WEBER-STEPHEN PRODUCTS LLC
www.weber.com
®
© 2011 Designed and engineered by Weber-Stephen Products LLC
a Delaware limited liability company, located at 200 East Daniels Road, Palatine, Illinois 60067 U.S.A.
Printed in U.S.A.