Weber SRV 300, Руководство по эксплуатации и техническому обслуживанию, Страница: 13 / 24

13
2
1
1
3
2
1
1
Starting
After horizontal transport: Bring tamper into a vertical
position and wait several minutes until the engine oil
has collected in the lower area of the crankcase.
After the engine has started up, slide the choke lever (1)
to the right (open).
Bring the gas lever into full-throttle lock-in position.
Slowly tighten the handle (1) of the reversing starter (2) until
resistance is noticeable.
Allow the handle (1) to glide back into the initial position
before completely pulling it through with both hands.
Allow the engine to warm up for a few minutes.
When starting in enclosed spaces ensure adequate
ventilation – danger of suffocation.
Never use any starter spray.
(Close) choke lever (1).
Press priming pump (2) at least 3 times until hose (3) is filled
with gasoline.
Tamping
Bring the gas lever (1) into full-throttle lock-in position.
Compacting is only permissible at the full throttle gas lever
position as there is an increase level of wear in the slip
range of the centrifugal clutch.
At obstructions (walls, pits, etc.) ensure that no one can
be caught between the machine and the obstruction; or
ensure that the machine does not slip into the pit.
Only run machine within reach of the manual guidance
rod (1).
Unauthorized persons are forbidden from being in the area
of the tamper during the compacting process.