Weber Spirit PREMIUM E-310, Руководство пользователя

Страница: 12 / 28

12
WWW.WEBER.COM
PREPARING TO USE YOUR BARBECUE
1
2
5
4 3
PARTIAL DISASSEMBLY OF YOUR
BARBECUE FOR A LEAK CHECK
In order to do the leak check, you need to have access to
the gas valves, which will require some simple barbecue
disassembly .
Confirm that Barbecue Is Off
A) Turn gas supply off at source .
B) Check that
ALL
burner control knobs are in the
off ( ) position
(1)
. Burner control knobs are shipped
in the off ( ) position, but you should check to be sure
that they are turned off . Check by pushing burner
control knobs in and turning them clockwise . If they
do not turn, they are off . If they do turn, continue
turning them clockwise until they stop; then they are
off . If your barbecue has a side burner, make sure the
side burner control knob is turned off .
Remove Control Panel
You will need: A Phillips screwdriver .
A) Disconnect the two wires from the igniter button
located on the underside of the control panel
(2)
.
NOTE: Pull from terminals at ends of wires.
B) Remove burner control knobs
(3)
.
C) Remove the screws from the front of the control panel
with a Phillips screwdriver
(4)
.
D) Carefully lift control panel up and then pull forward
away from frame
(5)
.
Your barbecue is now ready for a leak check . Proceed to
“CHECKING FOR GAS LEAKS .”
Safety must be considered when you are
deciding where to place and operate your
barbecue. Be sure to read the following
warnings before installing or using your
barbecue.
WARNINGS:
m
Only use this barbecue outdoors in a
well-ventilated area. Do not use in a
garage, building, breezeway or any other
enclosed area.
m
Your gas barbecue shall not be used
beneath overhead combustible
construction.
m
Your gas barbecue is not intended to be
installed in or on recreational vehicles
and/or boats.
m
Do not use the barbecue within 61 cm
(24 in) of combustible materials. This
includes the top, bottom, back or sides of
the barbecue.
m
Keep the cooking area clear of
flammable vapors and liquids such as
gasoline, alcohol, etc., and combustible
materials.
m
The entire cookbox gets hot when in use.
Do not touch.
m
Do not move the gas barbecue when
operating or while barbecue is hot.
WHAT IS A LEAK CHECK?
The fuel system in your
barbecue features connections
and fittings. A leak check is a
reliable way to make sure that
no gas is escaping from any of
the connections or fittings.
Although all factory-made
connections have been
thoroughly checked for gas
leaks, it’s important to perform
a leak check before using your
barbecue for the first time, as
well as anytime you disconnect
and reconnect a fitting and
each time you perform routine
maintenance.