Weber Skyline 3200, Руководство пользователя

Страница: 29 / 72

WWW.WEBER.COM
®
29
TROUBLESHOOTING
GENERAL TROUBLESHOOTING
PROBLEMS SOLUTIONS
Burner does not ignite when you push the
igniter button.
Be sure that there is gas flow to the burners by attempting to match light your burners. Refer to “BURNER
IGNITION—Lighting with a Match.” If match lighting is successful, the problem lies in the ignition system. Refer to
“MAINTAINING THE ELECTRONIC IGNITION SYSTEM.”
Be sure that wires are correctly inserted into terminals on igniter electrode assembly. Check that the wires are
connected to terminals on the electronic igniter module. Refer to “MAINTAINING THE ELECTRONIC IGNITION
SYSTEM.”
If a new battery is installed, confirm that battery’s plastic wrapping has been removed. Verify that the battery is in good
condition and has been installed correctly. Refer to “MAINTAINING THE ELECTRONIC IGNITION SYSTEM.”
Burner does not ignite, or flame is low when burner
control knob is on high ( ) position.
Fuel hose could be bent or kinked. Straighten fuel hose.
Burner flame pattern is erratic.
Flame is low when burner control knob is on high ( )
position.
Flames do not run the whole length of the
burner tube.
Clean burner ports that run down the entire length of burner tube. Refer to “ANNUAL MAINTENANCE.”
Burners burn with a yellow or orange flame, in
conjunction with the smell of gas.
Inspect spider/insect screens for possible obstructions. (Blockage of holes.) Clean spider/insect screens.
Refer to “ANNUAL MAINTENANCE.”
Experiencing flare-ups.
m
CAUTION: Do not line the cookbox
with aluminum foil.
Grill must be preheated with all burners on high for 10 to 15 minutes.
Clean the cooking grates thoroughly to remove grease. Refer to “CLEANING THE INSIDE OF THE GRILL.”
The cookbox may be dirty and is not allowing grease to flow into removable catch pan. Clean cookbox. Refer to
“CLEANING THE INSIDE OF THE GRILL.”
Inside of lid appears to be “peeling.”
(Resembles paint peeling.)
The inside of the lid is cast aluminum. It is not painted. It cannot “peel.” What you are seeing is baked-on grease that
has turned to carbon and is flaking off. THIS IS NOT A DEFECT. Clean thoroughly. Refer to “CLEANING THE INSIDE OF
THE GRILL.”
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site.
Log onto www.weber.com.
GRILL OUT
®
HANDLE LIGHT TROUBLESHOOTING
PROBLEMS SOLUTIONS
Grill Out
®
Handle Light does not light. If a new battery is installed, confirm that battery’s plastic wrapping has been removed. Verify that the battery is in good
condition and has been installed correctly. Refer to “MAINTAINING THE GRILL OUT
®
HANDLE LIGHT.”
Light will activate only when lid is open and power button is ON. Lift lid to up position and push power button on.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site.
Log onto www.weber.com.