22
Figure 32
View from rear
of barbecue
Hinge rod
Slot in frame
(view from below)
Insert one end of the hinge rod into the hole in the frame.
Figure 32 (a).
Insert the other end into the hole in the swing table end
bracket. Figure 32 (b). Hold the end bracket at an angle so
the lower tab is inside the frame tube. Push the bracket into
the frame. Check to see that the lower tab of the bracket is
hooked in the slot in the frame. Figure 32 (c).
To fully seat the bracket, you may have to tap it lightly with
a hammer.
WARNING: If swing table end bracket is in any way
cracked or damaged, do not use swing table. Call your
dealer to order a new part.
WARNING: The load limit for the swing table is
30 pounds.
(b)
(c)
(a)
Figure 33
Figure 34
To lower table: Pull support rod up to disengage slide lock
and lower table. To raise table, lift table up and engage
slide in locked position. Figure 34.
F
Notch
Slide bar
Unlocked position
Slide
Support rod
Locked position
Wheel frame
View from front
of barbecue
Position slide bar assembly on the outside of the wheel
frame. Put a nylon washer on each 1 3/4 inch screw, insert
screws through wheel frame and slide bar assembly and
add nylon washers and hex nuts. Tighten nuts using a
screwdriver and pliers. Figure 33.
