Weber Genesis SMART EX-325s, Руководство пользователя

Страница: 20 / 28

20
Tr
oub
le
sho
ot
in
g
REPLACEMENT
PARTS
To obtain replacement parts,
contact the local retailer
in your area or log onto
weber.com.
MAIN BURNER(S) WILL NOT IGNITE
SYMPTOM
• Main burners do not ignite when following the electronic ignition instructions in the “Operation” section of this owner's
manual.
CAUSE SOLUTION
There is a problem with gas flow. If any burner does not ignite, the first step is to determine if there is gas flowing to the burner(s). To check
this, follow the instructions below for “Lighting Your Grill with a Match.”
If
match lighting IS NOT successful , follow the “GAS FLOW” troubleshooting suggestions on the next page.
There is a problem with the electronic ignition system. If any burner does not ignite, the first step is to determine if there is gas flowing to the burner(s). To check this,
follow the instructions below for “Lighting Your Grill with a Match.”
If
match lighting IS successful , follow the instructions for “Checking the Components of the Electronic
Ignition System.”
A
B
Lighting Your Grill with a Match
Using a Match to Determine if there is
Gas Flow to the Main Burners
1) Open the grill lid.
2) Check that all burner control knobs (including side
burner control knob) are in the off position. Check
by pushing in and turning knobs clockwise.
3) Turn the gas supply valve on.
4) Begin with the burner furthest to the left. Put
match in the matchstick holder and strike match.
(Matchstick holder is located under left side
table.) Insert lit match down through the cooking
grates, past the FLAVORIZER bars and next to the
burner
(A)
.
5) Push the burner control knob in and slowly turn it
counterclockwise toward the start/high position.
6) Check that the burner is lit by looking through
the cooking grates and through the cutout in the
FLAVORIZER bar.
7) If the burner does not ignite within 4 seconds,
turn burner control knob to the off position and
wait five minutes to allow the gas to clear before
attempting to light the burner again. If repeated
attempts fail, follow the gas flow troubleshooting
instructions on the next page.
8) If the burner ignites, the problem lies in the ignition
system. Follow the instructions for “Checking the
Components of the Electronic Ignition System”.
9) Replace the matchstick holder by hanging
underneath left side table (B) .