Weber mt SRV 660, Руководство по эксплуатации и техническому обслуживанию

Страница: 18 / 24

18 SRV 660
Unscrew the screw plug (1) from the fill opening.
Tilt the tamper forward slightly and let the old oil drain into a
suitable collection container. Tilt the tamper back and fill oil
in as specified.
Clean the screw plug and screw it into the fill opening.
Changing the tamping foot
Unscrew the 4 nuts (1).
Lift the tamping foot (2) off of the tamper and attach a new
tamping foot.
Mount the fastening nuts of the tamping foot using the
plate springs as shown in the adjacent illustration.
1
2
Mounting
arrangement of the
plate springs
1
0.6 - 0.7 mm
1
Adjusting/replacing the spark plug
Pull off the spark plug connector (1) and unscrew spark plug.
Clean the electrode (1) of the spark plug.
Measure the electrode air gap (1), the gab should be 0.6 - 0.7
mm.
Correct the electrode air gap or replace the spark plug if
necessary.
Only use spark plugs with the correct thermal value.
Changing the oil in the tamping system
1
This work may only be carried out when the engine is cold.
All maintenance work: select a collection vessel that
is large enough to prevent oil from spilling onto the
ground. Dispose of waste oil in an environmentally
friendly manner (regulation on waste oils).
Dispose of oils, oil-soaked cloths, and parts replaced
and smeared with oil in an environmentally friendly
manner.
Change the fuel filter
Pull the fuel line (1) off of the fuel filter (2).
Replace fuel filter.
1
2
When mounting the new tamping foot the nuts (1) must
be tightened with a torque of 35 Nm.