Weber Motor MPE 850, Руководство по обслуживанию

Страница: 26 / 86

26 SHB MPE850 Rev 1.2 | 408014 | 408090 | 408101 |
1
2
3
4
4.3.3 Checking oil level
Information!
Your engine uses a dry sump lubrication system. Engine oil is pumped from the
engine into the oil tank while the engine is operating. When the engine is switched off, a portion of the
engine oil flows from the oil tank slowly back into the engine. Therefore inspect the oil level immediately
after switching off the engine.
Check the oil level with a warm engine.
► Warm up the engine. (See the vehicle
manufacturer‘s documentation.)
CAUTION! Scalding caused by hot engine oil.
Wear protective gloves.
► Unscrew the oil dipstick
1
at the oil tank.
► Wipe the oil dipstick and insert into the oil
tank. Do not screw in.
► Remove the oil dipstick
2
and check oil
level.
The oil level must be between the
MIN-marking 4 and the MAX-marking
3 .
NOTICE! Engine damage caused by a lack of
engine oil.
► When oil level is below the MIN-marking,
continue with the section Refilling engine
oil .
NOTICE! Engine damage caused by too much
engine oil.
► When oil level is exceeded the MAX-
marking, pump out excessive engine oil with
oil suction pump.
► Screw in the oil dipstick.
4 Operation
4.3 Service before driving