Webb WER18SP, Руководство оператора, Страница: 9 / 24

CAUTION : To avoid engine problems, the fuel system should be emptied before being stored for 30 days
or more. Empty the fuel tank, start the engine and let it run until the fuel lines and carburettor are empty.
Use fresh fuel for your next use of the machine. See Storage Instructions for additional information.
Never use engine or carburettor cleaner products in the fuel tank or permanent damage may occur.
START ENGINE
To start the engine, first make sure that the spark plug is tightened and that the machine is filled with
sufficient oil and petrol.
NOTE: Due to the protective coating on the engine, a small amount of smoke may be present during the
initial use of the product and should be considered normal.
Press the primer bulb 3 times to allow fuel into the engine (for the first use, press 5 times).
Hold the Operator Presence Control bar down to the handle and pull the starter handle quickly.
Do not allow the starter rope to snap back.
STOP ENGINE
z
To stop engine, release the Operator Presence Control bar.
z
Disconnect the spark plug cap if the lawnmower is to be left unattended.
MOWING TIPS
z
Under certain conditions, such as very tall grass, it may be necessary to raise the height of the cut to
reduce the pushing effort and to keep from overloading the engine and leaving clumps of grass
clippings. It may also be necessary to reduce ground speed and/or run the lawnmower over the area a
second time.
z
For extremely heavy cutting, reduce the width of cut by overlapping the previously cut area and mow
slowly.
z
Pores in cloth grass catchers can become filled with dirt and dust during use and catchers will collect
less grass. To prevent this, regularly hose the catcher off with water and let it dry before using.
z
Keep the top of the engine around the starter clean and clear of grass clippings and chaff. This will
assist engine air flow and extend engine life.
MAINTENANCE
IMPORTANT-Regular, careful maintenance is essential for keeping the safety level and original
performance of the machine unchanged over time.
1) Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition. Regular
maintenance is essential for safety and performance.
2) Never store the equipment with fuel in the tank inside a building where vapour may reach a flame,
spark or source of extreme heat.
3) Allow the engine to cool before storing in an enclosed space.
4) To reduce the fire hazard, keep the engine, exhaust silencer, battery compartment and fuel storage area
free of grass, leaves, or excessive grease. Remove grass cuttings from containers before storage.
5) Do not use equipment with worn or damaged parts. Parts should be replaced not repaired. Only use
genuine spare parts. Parts that are not of the same quality can damage the equipment and create safety
hazards.
6) If the fuel tank has to be drained, this should be done outdoors and when the engine is cool.
7) Wear strong work gloves when removing and reassembling the blade.
8) Check the blade’s balance after sharpening.
8