Webb 1938266001, Оригинальное руководство пользователя

Страница: 12 / 32

12
TRANSPORT WHEELS
1. Place Wheel Pin Ø8x70 (A) through Washer (B) and then Transport Wheel (8).
2. Fit this to the outside of the Frame (5) and slide through the fixing hole.
3. When the Wheel Pin Ø8x70 is through the frame, slide a second Washer (B) on the Wheel Pin and secure
with a Split Pin (C) being placed through the eyelet at the end of the Wheel Pin and split the two legs of
the Split Pin, to secure.
4. Fit the Wheel Trim (A) to the Wheel (B).
5. Repeat with the second Transport Wheel.
MOTOR HOUSING & FRAME
1. Place the Motor Housing upside down (12) with the loading slot (1) on the ground (Fig. 5).
2. Place the Frame (5) on to the Motor Housing (Fig. 5). Ensure the exit chute of the Motor Housing is aligned
with the exit chute of the Frame.
3. Attach both components with the 6x Screw M5x20 into the correct holes (Fig. 5).
COLLECTOR
Important: Before you attach the collector, please ensure that the motor is switched off and the blade/tines
are not rotating.
1. Turn the machine back onto it’s feet and transport wheels.
2. Place the locking mechanism (3) on the collector (6) into its lowest position (Fig. 6).
3. Push the collector fully into the frame (Fig. 6).
4. Push the locking mechanism (3) on the collector (6) back into its highest position (Fig. 6).
PLEASE NOTE, THIS MACHINE WILL NOT OPERATE WITHOUT THE COLLECTOR AND LOCKING LEVER FULLY
LOCKED INTO POSITION. THE MACHINE IS FITTED WITH A SAFETY SWITCH FOR YOUR OWN HEALTH AND
SAFETY.
OPERATION
IMPORTANT:
The shredder can only be started if the collection box (6) has been pushed into the frame (5) and the locking
device (3) is in the upper position.
WARNING
Always switch the motor off and remove the electrical plug from the power source before making any
adjustments, repairs, or maintenance.
ELECTRICAL CABLE
1. Always route the electrical cable away from the work area, to prevent it from meeting the cutting device.
2. Plan your route before starting work. Start your work at the nearest point to the electrical outlet and work
away from it.
3. A 13 AMP (BS1363/A) plug must be used, and a 13 AMP fuse must be fitted.
NOTE: If a molded plug is fitted and must be removed, take great care in disposing of the plug and severed
cable, it must be destroyed to prevent engaging into a socket. If the supply cable is damaged, it must be
replaced by a service agent or certificated electrician, to ensure the machine can be used safely
INSTRUCTION MANUAL