6
Use the following link to obtain version specific controller operation instructions.
http://www.techwebasto.com/documentation/heater/recreational.html
Timer &
Date
Time & Date allows user to properly set the current date and time. User also
has the ability to switch between AM/PM and 24 hour format. If the 24 hour
format is selected the date format will change to dd/mm/yyyy. Use the rotary
knob to choose the time / date and the selection button to confirm each
entry. The Webasto button can be used to go back to the previous field if
additional changes are needed.
AM/PM
mm/dd/yyyy
Timer
There are 4 heater start-up cycles possible 7 days per week. The timer is separated into to
three categories. The user can select “Mon-Fri”, set each specific timer (T1 – T4) for a typical
work week all at once. A weekend “Sat-Sun” can be scheduled in the same manner or a full
week by using the “Mon-Sun” selection. The “custom” link allows the user to set a specific
timer (T1 – T4) for each individual day.
When selecting a specific timer a sub-menu will appear (Edit, Skip, and Off). To change the
timer cycle, select “edit”. Changes are saved immediately. The “skip” feature allows a timer
cycle to be skipped one time within a 7 day period. Timer will reactivate after this one-time
skip cycle.
Note:
To turn a specific timer off permanently select “off”.
LVD
LVD “Low Voltage Disconnect” allows the user to adjust the battery voltage
level at which the Webasto SmarTemp Control fx will shut the heater off. A
warning (LED and message) will appear after 8 minutes of low voltage. The
warning will remain on for 2 minutes before the heater is shut off.
If battery voltage is equal to or less than the threshold se0.1v, the
heater will not start. i.e. if an 11.5v threshold is selected the heater cannot be
started until B+ has reached 11.7v.
12 volt
- Range between 11v – 12.5v |
24 volt
- Range between 21v – 25.5v
11.4v |
24.2v
Default
Default allows the user to perform a reset to all default values.
Note:
A power loss will not reset user programmed values.
N/A
Password
A password can be set to prevent access to the advanced “Options” menu.
Enter a 4 digit code passcode to begin securing the Options menu.
Note:
This
is typically used in fleet vehicle applications.
OFF
Hour
Meter
The hour meter logs the operating hours of an active ON signal to the heater.
This does not reflect the true runtime of the heater itself.
Note:
For warranty purposes a diagnostic printout is still required where
applicable. This hour meter is for reference only!
N/A
SW
Version
This displays the firmware version of the Webasto SmarTemp Control fx.
Installed
Version
Back
Select this to return to the previous screen.
N/A
IMPORTANT -
The Red status indicators (heater "ON") and LCD screen backlight turn off after 30 seconds.
A touch of any button or a turn of the rotary knob will re-activate these lights. If the "Webasto" button is
used to re-activate these lights, an additional press of this button is necessary to turn the heater off. Note
that when the heater is "ON" the display is active.
