Webasto Azimut 43 Fly, Технический сервисный бюллетень

Страница: 4 / 12

Code Description Possible
Default
Recommended
Chiller CPAC AirH.
2 T cut-out in heat cycle.
Min. 35/ Max.55 ˚C
With external heater
(e.g. Thermo90S/ST)
set 55˚C.
On Reversed cycle set
42˚C max. or less.
Be aware of right
settings for each
component.
40 Chiller
45 CPAC
(00 Air
handler)
● ●
3
T cut-in in heat cycle.
Min. 35/ Max.55 ˚C
37 Chiller
38 CPAC
● ●
4 Calibration evaporator
or chilled water
temperature sensor. Min. -
9.9 / Max. 9.9 ˚C 0.0 ● ● ●
5
Time delay in minutes
before display will go in
sleep mode. In sleep
mode LED will flash at
30 sec. interval to
signal active status. Min. 5 / Max.60
minutes 15
● ● ●
6 Time delay in seconds
of first start-up after AC
supplied to stage
multiple units with
independent
controllers. Min.01 / Max.20
seconds 01 Chiller /
CPAC
05 Air handler
● ● ●
7 Calibration room
temperature sensor. Min. -
9.9 / Max. 9.9 ˚C 0.0 ● ● ●
8
Calibration AC Voltage
50Hz. Min.-20/ Max.20 Hz 00
● ● ●
9
Setting relay
R2.(Chiller) 00 = Staging relay.
01 = Air handler 3-way
valve controlling.
02 = Alarm indication.
03 = Cycle indication. 00 Chiller / Air
handler
●
De-icing.(CPAC) 00-99 minutes anti
short cycle delay on
de-icing. 02 CPAC
●
A Calibration AC Voltage
60Hz. Min.-30/ Max.20 Hz 00 CPAC
-10 Air handler
● ● ●
b Actual software version. When version b1.00 or
higher is shown all
settings can be reset
to default by pressing
UP till INIT is shown.
4.** Chiller
5.** CPAC
6.** Air handler
● ● ●
c Pump 1 outlet setting 00 = continuous 01 =
staged 00
●
d
Lower VDC output
Pump 1 Min.12 / Max.18 Volts 12
●
E Higher VDC output
Pump 1 Min.12 / Max.18 Volts 18
●
F N/A 00 / 01 01
●