STEP 14
Install rear (tailgate side) mounting feet to the truck bed. It is recommended to use the single center hole in the mounting pad for
securing the rear feet when possible. (If the vehicle is a 2016 or newer Chevrolet/GMC truck refer to Step 13). Insert the hardware,
using (1) Part J, (1) Part C, and (1) Part M, into the stake pocket and thread the stake pocket bracket (Part J) to the end of the bolt.
Insert the stake pocket bracket into the stake pocket by tilting the foot assembly and inserting the bracket diagonally into the stake
pocket. Loosely tighten the stake pocket bracket then install the no drill mount bracket (Part E) to the front most mounting foot
clamp insert hole using (1) Part A, (1) Part K, and (1) Part E. Tighten hardware, making sure mounting foot is secured to the bed rail.
STEP 15 2016 or Newer Chevrolet/GMC Trucks Only
Use the stake pocket side mount in the rear stake pockets only. This will mount in the stake pocket via the side hole.
This will also replace the stake pocket bracket for the rear. Install the no-drill mounting bracket (Part U) to the rear most
mounting hole using (1) Part R, (1) Part S, and (1) Part T. Tighten hardware, making sure mounting foot is secured to the bed rail.
Repeat on opposite rear stake pocket.
7
©2019 Werner Co.
U
T
S
R