7
ASSEMBLY
●
Repeat the same procedure to install the back panel #22 to its proper
position.
Step 7: Install roof cover
●
●
Lay the camo roof #20 on the ground next to the shed frame. Make sure
that the ends with the black straps are alongside the front door/back
panels #21,#22 and the tube sleeves are facing upward (fig. 17).
17
●
Stretch the camo roof #20 over the shed frame and make sure it is centered
on the frame (fig. 18). Use a ladder if necessary.
18
Caution!
●
If small adjustments are needed, two people should
pull the camo roof #20 from the same side so that it
does not twist.
●
Loosen the bottom cross rails #7,#8 from the frame. Slide the cross bottom
rails #7,#8 through the tube sleeves on one side of the camo roof #20.
Re-assemble the clamps #13,#14and fitting #15,#18,#17 and tighten
19
●
Repeat the same procedure for the other side of the camo roof #20.
●
Check and make sure all the bottom cross rails #7,#8 are horizontal
and of the same height from the ground.
●
Tighten all the nuts and bolts at this stage.
Caution!
●
Check and tighten the bottom cross rails #7,#8 and
ratchets #26 monthly to ensure that the camo roof
#20 is tight and safe.
●
When disassembling the shed, press the
spring-loaded bar and open the ratchet handle
completely to pull out the strap (fig. 21).
21
Spring-loaded bar
slightly (fig. 19).
20
Black straps
Tube sleeves
20
13
Tube sleeve
inside tube sleeve
15
bottom cross rail (7,8)
18
17
15
14
18
18
17
There are pipe sleeves along the lower part of each side inside
the camo roof #20.
Thread the strap through the spindle of the ratchet, raise and lower the
●
handle two or three times to wind the strap onto the spindle
.
(fig. 16)
14
16
Insert the S-hook of the rachet
into the hole of
#26 on the four corners
the bent corner leg #3.
Raise and lower the rachet handle repeatedly to tighten the strap (fig.20).
●
●
●
Now the shed is ready for use.
20