WE-EF FLC230-CC, Инструкция по установке и обслуживанию

Страница: 4 / 8

3
Installation
The product must be installed and maintained by a suitably
qualified professional in compliance with latest building/
construction and/or electrical regulations and relevant
legislation.
Warning: Switch off
and isolate
mains electrical supply
prior to installing and connecting the luminaire. Do not
open
the
luminaire while mains supply is switched on.
Notice: If the luminaire is modified by anybody other than
the original manufacturer, then the warranty will no longer
be valid and shall become the full responsibility of the
modifying person/organisation. Claims based on defects
attributable to improper installation and/or application, and
the consequences thereof, are excluded.
In case of component failure due to abnormal
circumstances or at end of life, replacement must be carried
out by a suitably qualified and trained professional.
In case of questions please contact our technical hotline:
+
61 458 933 399
(from Monday - Friday from 0
7
.00 until
1
9
.00 hours.
Installation Procedure
1)
Prior to electrical connection, proceed with mechanical
installation by firmly fixing stirrup A to optional mount-
ing accessory or directly to a suitable surface.
Aim luminaire.
Caution: Make sure not to damage any electric cable,
water pipe or other devices while drilling holes.
2)
Switch off
and isolate
the mains electrical supply.
3)
Remove gear box cover B by releasing screws C .
4)
Check that rating shown on the luminaire label con-
forms with the mains electrical supply.
5)
Feed mains supply cable D through cable gland E .
An
additional M20 gland is supplied to allow loop
through of supply cabling or alternative DMX cabling
arrangements.
6)
Connect to the correspondingly marked contacts of
terminal F , according to the wiring diagram. Tighten
cable gland E firmly.
7)
Reposition gear box cover B and tighten screws C
evenly.
8)
Loosen the two screws G slightly. Aim luminaire (see
illustration), tighten screws G firmly ( 100Nm ).
In addition, tighten screw H (max. 6Nm ) to secure
orientation of luminaire.