12
LUMINAIRE INSTALLATION:
1.
SWITCH OFF MAINS ELECTRICAL SUPPLY.
2.
CHECK THAT ELECTRICAL SUPPLY CONFORMS WITH THE RATINGS SHOWN ON THE FIXTURE.
3.
MAKE THE SUPPLY CONNECTIONS WITH THE LUMINAIRE CABLE A.
4.
REMOVE TWO SS MOUNTING SCREWS Q FROM THE MOUNTING RING E AND SET THE LUMINAIRE INTO THE
BLOCKOUT E/O.
5.
REMOVE THE LENS FRAME G AND LENS/GASKET ASSEMBLY H/I BY REMOVING THE SIX FLATHEAD SCREWS J.
6.
ATTACH LUMINAIRE TO THE MOUNTING RING E WITH THE TWO SCREWS REMOVED IN STEP 4 THROUGH THE
LUMINAIRE FLANGE INTO THE THREADED BOSSES IN MOUNTING RING E.
7.
TO ADJUST THE LIGHT DISTRIBUTION, LOOSEN SCREWS
K
AND
L
. NOW THE ANGLE OF ROTATION AND
INCLINATION TO THE OBJECT TO BE ILLUMINATED MAY BE ADJUSTED. FIX POSITION BY TIGHTENING SCREWS
K
AND
L
.
8.
ENSURE THE SEALING SURFACES OF THE LENS GASKET
I
AND LUMINAIRE ARE CLEAN AND FREE OF DEBRIS.
PLACE THE LENS/GASKET ASSEMBLY INTO THE LUMINAIRE WHILE ALIGNING THE STUD ON THE TOP FLANGE OF
THE HOUSING WITH THE CORRESPONDING HOLE IN THE GASKET. NOTE THAT THERE ARE RECESSES IN THE
BOTTOM OF THE GASKET TO ACCOMMODATE THE SCREW HEADS USED IN STEP 6.
9.
PLACE THE LENS FRAME
G
ON TOP OF THE GASKET/LENS ASSEMBLY AND FASTEN THE SIX FLAT HEAD SCREWS
J
IN A CRISS-CROSS PATTERN UNTIL ALL SIX ARE PROPERLY SEATED. REPEAT UNTIL A FINAL TORQUE OF 60 IN-LB
(6.78NM) IS ACHIEVED.
10.
IN LOCATIONS OF HIGH HUMIDITY, LEAVE THE SCREWS
J
UNTIGHTENED AND LIGHT THE FIXTURE FOR 30
MINUTES OR MORE TO ALLOW MOISTURE TO EVAPORATE. THEN TIGHTEN THE SCREWS AS DESCRIBED IN STEP
9.
Содержание ETV13-CC/TW Series
