WCS WPL VSF04, Руководство по эксплуатации и обслуживанию, Страница: 13 / 26

Operation & Maintenance Manual
12 | P a g e
UPTHRU ST FR OM
WATER TABLE
T ank
Base
5.4 Installation of Kiosk
- Step 1 Lay a concrete slab to suit the kiosk, above the adjacent surface water level (and the
flood plain) to avoid surface water ingress. Provision for servicing ducts for air lines, cables
and mains power should be made.
- Step 2 Lay the ducting from the kiosk to the unit, mains supply and any pumping chambers or
sand filter.
- Step 3 A mains electricity supply is required into the kiosk.
- Step 4 Secure kiosk to the slab through the unistrut and seal to the concrete with mastic. Do
not secure until the concrete slab has fully cured.
5.5 Connections to kiosk
- Step 1 The air hoses will have been delivered lying on top of the filter section of the unit.
Feed the hoses down the duct and connect to the bulk head connectors on the top of the
unit (or turret if fitted). Jubilee clips are either secured to a blower or in the delivery
envelope. Ensure there are no kinks in the lines. Then cut the air lines to length to allow
connection to the blower in the kiosk without any sharp bends. It should be noted that the
pipe becomes warm during operation, softens and may deform at sharp bends.
- Step 2 Electrical connections – See Section 7, Page 14.