3
wibenchmfg.com
507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
Assembly Instructions
Before you begin, please make sure all parts and proper quantities are included. (See Part Identifier Key) Any parts damaged during shipment must be
reported within 24 hours of receipt. To report information regarding damages or if you have any questions, please call 800.242.2303.
Step 1:
• Remove starter right leg from the Study Carrel by unscrewing
the L-bracket from the leg. (leave the bracket attached to the
top) You will need to tip the starter unit enough so you can
slide the right leg out of the connector by pulling down on the
right leg. Somone will need to support the starter unit until
you attach the adder center leg.
Step 2:
• Locate the adder center leg from the adder kit. Align the
connector on the adder center leg with the connector on the
modesty panel and press down until it’s fully engaged.
Step 3:
• Re-fasten the L-bracket to the inner side of the adder center leg
using #10x3/4” square pan screws. Tighten with a #2 square drive
screw driver or a #2 square bit with a screw gun.
Step 4:
• Attach (2) 4” L-brackets to the outer side of the adder center leg
aligning them with the pre-drilled holes using #10x3/4” square
pan screws. Tighten with a #2 square drive screw driver or a
#2 square bit with a screw gun. Repeat this step for the starter
right leg that you just removed but the pre-drilled holes will be
located on the inner side of the leg.
Step 5:
• See page 1 of the
Assembly Instructions for the Starter Kit
.
You will continue with
Step 2
and go through
Step 6.
Step 6:
• Repeat above steps for any additional Adder Kits. Make sure
starter right leg will be at the end of the assembly process.
Study Carrel
Adder Kit
Step
1-3
Step
4
Starter right leg
Adder center leg
Adder center leg
Starter right leg
