Wayne CWS Series Скачать руководство пользователя страница 2

2

www.waynepumps.com

Operating Instructions and Parts Manual

REMINDER: Keep your dated proof of purchase for warranty purposes! Attach it to this manual or file it for safekeeping.

DESCRIPTION

Jet pumps are single stage domestic water pumps designed for pumping 
potable water in applications where the water is up to 90 feet below 
pump center line. A pressure switch is a standard feature. A built-in 
control valve is available on deep well pumps. Deep well pumps must 
be mounted to either a pre-charged, conventional type, or free standing 
pressure tank. A Wayne jet assembly is required (not included) for 
operation of this pump.

UNPACKING

Inspect this unit before it is used. Occasionally, products are 
damaged during shipment. If the pump or components are 
damaged, return the unit to the place of purchase for replacement, 
or call Customer Support (800-237-0987).

SAFETY SIGNAL WORDS

To help recognize this information, observe the following signal words/
hazard classifications.

  Danger indicates an imminently hazardous  

situation which, if not avoided, WILL result in death or serious injury.

  La mention Danger indique une situation 

dangereuse imminente qui, si elle n’est pas évitée, ENTRAÎNE la mort ou 

des blessures graves.

  Warning indicates a potentially hazardous  

situation which, if NOT avoided, COULD result in death or serious injury.

  La mention avertissement indique une 

situation potentiellement dangereuse qui, si elle n’est pas évitée, risque 

d’entraîner des lésions corporelles graves ou même la mort.

   Caution indicates a potentially hazardous 

situation which, if NOT avoided, MAY result in minor or moderate injury.

 

MISE EN GARDE

   La mention mise en garde indique une 

situation potentiellement dangereuse qui, si elle n’est pas évitée, 

pourrait entraîner des blessures mineures ou modérées.

  Notice indicates important information, that if  

not followed, may cause damage to equipment.

This is the safety alert symbol. It is used to alert you to potential 

bodily injury hazards. Obey all safety messages that follow this symbol 

to avoid possible harm.

NOTE: 

Information that requires special attention.

GENERAL SAFETY INFORMATION

CALIFORNIA PROPOSITION 65

T

his product can expose you to chemicals, including DEHP, 

which is known to the State of California to cause cancer, 

birth defects and reproductive harm. For more information, 

go to www.P65Warnings.ca.gov.

Ce produit peutvous exposer à des produits chimiques, 

notamment du DOP, reconnus par l’État de Californie comme 

étant cancérigènes et à l’origine d’anomalies congénitales 

et de problèmes de l’appareil reproductif. Pour plus de 

renseignements, visiter le site www.P65Warnings.ca.gov.

GENERAL SAFETY

1.  Read all manuals included with this product carefully. Be thoroughly 

familiar with the controls and the proper use of the 
equipment.   

2.  Know the pump application, limitations and potential 

hazards.

  Always install a pressure relief valve to match 

the system pressure rating and the maximum flow rate.

  TOUJOURS installer une soupape de surpression 

correspondant à la pression nominale et au débit maximal du système.

  Do not use to pump flammable or explosive 

fluids such as gasoline, fuel oil, kerosene, etc. Do not use in explosive 

atmospheres. Pump should be used to pump ONLY clear water. Failure to 

follow this warning will result in death or serious injury, and 

void warranty.

  Ne pas utiliser pour pomper des 

fluides inflammables ou explosifs tels que l’essence, le 

mazout, le kérosène, etc. Ne pas utiliser dans des environnements 

explosifs. Pomper UNIQUEMENT de l’eau claire. Le non-respect de cet 

avertissement entraînera la mort ou des blessures graves, annuler la 

garantie..

Содержание CWS Series

















Отзывы: