Way Train 250S, Инструкция по эксплуатации

Страница: 16 / 43

9-6.ADJUSTING CUTTING WIDTH
First loosen clamp knob (A) (fig. 8). Move the left blade guide bar
to the suitable position. Then tighten clamp knob (A).
A
Fig.8
9-7.ADJUSTING BLADE GUIDE ROLLER BEARINGS, CARBIDE BLADE
GUIDES AND BACK-UP BEARINGS
G
B
H
K
A
Fig.10 D
Before making the following adjustments, make sure
the blade is tracking and tensioned properly:
1.The back of the blade (A) (fig. 9) should
F
ride against the back-up bearing (B).
To adjust, loosen set screw (C) and move
E
the guide block (D) up or down, until it lightly
touches the back of the blade.
2.The saw blade (F) should also ride between and
lightly touch the two blade guide roller bearings
(E) and (B) (fig. 9)
Fig.9
C
The front bearing (E) (fig. 9) is mounted
on an eccentric, and can easily be adjusted
to suit blade thickness by loosening set
screw (G) and turning shaft (E).
3.The carbide blade guides (H) (fig 9)
should also be adjusted so they lightly touch the blade by loosening screw (K).
4. The blade guide roller bearings, carbide guides and backup bearing on holder
(fig 9 and 10) should be adjusted in the same manner.
5. Cutting chips on the blade will be cleared by the steel brush.
14