1
•
DO NOT DRIVE WHILE DISTRACTED.
Any function that requires your prolonged attention should not be
performed while driving. Always stop the vehicle in a safe location before performing any such function. Failure
to do so may result in an accident.
•
KEEP THE VOLUME AT MODERATE LEVELS WHILE DRIVING.
Excess volume levels can obscure sounds such
as emergency vehicle sirens or road warning signals and may result in an accident. Continuous exposure to high
sound pressure levels may cause permanent hearing loss. Use common sense and practice safe sound.
•
FOR USE WITH 12V NEGATIVE GROUND VEHICLE APPLICATIONS ONLY.
Using this product other than in its
designed application may result in fire, injury or product damage.
•
MAKE THE CORRECT WIRING CONNECTIONS AND USE PROPER FUSE PROTECTION.
Failure to connect
wiring correctly with appropriate gauge and fuse protection may result in fire, injury or product damage . When
replacing fuse(s), never exceed the specified rating. Ensure proper protection of all system power wiring and
install an external fuse (not included) with specified rating for each amplifier connected with the +12V lead at
the battery terminal.
•
DISCONNECT THE NEGATIVE BATTERY TERMINAL BEFORE INSTALLATION.
Failure to do so may result in
fire, injury or damage to the unit.
•
D O NOT ALLOW CABLES TO BECOME ENTANGLED IN SURROUNDING OBJECTS.
Arrange wiring and cables
to prevent obstructions when driving. Cables or wiring that obstruct or hang up on places such as steering
wheel, brake pedals, etc. can be extremely hazardous.
•
DO NOT DAMAGE VEHICLE SYSTEMS OR WIRING WHEN DRILLING HOLES.
When drilling holes in the
chassis for installation, take precautions so as not to contact, puncture or obstruct brake lines, fuel lines, fuel
tanks, electrical wiring, etc. Failure to take such precautions may result in fire or an accident.
•
DO NOT UTILIZE OR CONNECT TO ANY PART OF VEHICLE SAFETY SYSTEMS.
Bolts, nuts or wires used in
the brake, airbag, steering or any other safety-related systems or fuel tanks should NEVER be used for
mounting, power or ground connections. Using such parts may disable control of the vehicle or result in fire.
WARNING
This symbol means important instructions.
Failure to heed them can result in serious injury or death.
CAUTION
•
STOP USE IMMEDIATELY IF A PROBLEM OCCURS.
Failure to do so may result in personal injury or damage to
the product. Return it to your authorized Wāvtech dealer
.
•
HAVE AN EXPERT DO THE WIRING AND INSTALLATION.
This unit requires special technical skill and
experience for wiring and installation. To insure safety and proper fun
ction, always contact the authorized
dealer where you purchased the product to have it done professionally.
•
INSTALL THE UNIT SECURELY WITH SPECIFIED PARTS.
Be sure to use only the included parts and specified
installation accessories (not included). Use of other than designated parts may damage this unit. Install the
unit securely so that it will not come loose during a collision or sudden jolt.
•
ROUTE WIRING AWAY FROM SHARP EDGES AND MOVING PARTS.
Arrange cables and wiring away from
sharp or pointed edges and avoid moving parts such as seat hinges or rails to prevent pinching or wear. Use
loom protection where appropriate and always use a grommet for any wiring routed through metal.
•
NEVER RUN SYSTEM WIRING OUTSIDE OR UNDERNEATH THE VEHICLE.
All wiring must
be routed, secured
and protected inside the vehicle. Failure to do so may result in fire, injury or property damage.
•
INSTALL THE UNIT IN A DRY AND VENTILATED LOCATION.
Avoid mounting locations where the unit will
likely be exposed to high moisture or heat without adequate ventilation. Moisture penetration or heat buildup
may result in product failure. Always make sure the amplifier chassis temperature is safe before touching it.
•
REDUCE GAIN AND SOURCE VOLUME TO MINIMUM LEVELS FOR INITIAL SYSTEM TUNING.
Ensure
amplifier power is off before connecting signal cables and follow proper system gain setting procedures.
Failure to do so may result in damage to the amplifier and/or connected speakers.
Package Contents:
Accessories Required for
Installation
(not included):
Ÿ
RCA Cables or Signal Wire
Ÿ
Power Supply & Speaker Wire
Ÿ
In-line Fuse Holder w/40A Fuse
Ÿ
Battery Ring Terminal
Ÿ
Chassis Ground Terminal
Ÿ
Wire Crimp Connectors
Ÿ
Grommets & Loom
Ÿ
Mounting Screws
WARNING
CAUTION
This symbol means important instructions.
Failure to heed them can result in injury or property damages.
Mounting Tabs
(pre-attached)
Spk Level
Input Terminals
Main Unit
Hex Wrenches
1+3/
2+4
CH1/2
INPUT
CH
FIL
TER
LEVEL
TRIM
CLIP
INPUT
CH
GAIN
CLIP
1/2
1+3/
2+4
1/2
3/4
5V
/
20V
10V
/
40V
OFF
LP
HP
(Hz)
50
500
(dB)
-6
+6
CH3/4
MIN
MAX
FIL
TER
LEVEL
TRIM
OFF
LP
HP
(Hz)
50
500
(dB)
-6
+6
GAIN
MIN
MAX
5V
/
20V
10V
/
40V
