The Click 330 has two different kinds of LEDs.
˽
At the top of each device are two green LEDs labeled US1 and US2, used for monitoring the power supply. US1 monitors the
first power supply (the one using the screw terminal marked US1) and US2 monitors the second (redundant) power supply.
Status
Meaning
On
Supply voltage is in an acceptable range
Off
Supply voltage is too low
˽
Each Ethernet port has two LEDs that show the data transmission speed of that port, as shown in the table below. These
LEDs are labeled 100/ACT and 1000/ACT. If the LED is on, there is an electrical link. If the LED blinks, there is currently
network traffic at that speed.
LED
10 Mbps
100 Mbps
1000 Mbps
100/ACT
On or blinking
On or blinking
Off
1000/ACT
On or blinking
Off
On or blinking
5
Monitor LEDs
WX-500-0196
© 2022 Wavetronix LLC. All rights reserved. Protected in the US by patents viewable at www.wavetronix.com/en/legal. Protected by Canadian Patent Nos. 2461411; 2434756; 2512689; and European Patent Nos. 1435036;
1438702; 1611458. Other US and international patents pending. Wavetronix, SmartSensor, Click, Command and all associated logos are trademarks of Wavetronix LLC. All other product or brand names as they appear are
trademarks or registered trademarks of their respective holders. Product specifications are subject to change without notice. This material is provided for informational purposes only; Wavetronix assumes no liability
related to its use.
