Dualwave-I Modem User Manual __________________________________________________ Care & Maintenance
DWI10012WT31 7
Wavenet
Technology
Compliance Statement
This equipment has been tested and found to comply with the limits for
a class B digital device, pursuant to Part 15 of the FCC rules.
These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the manufacturer’s instructions, may cause
interference harmful to radio communications.
There is no guarantee however, that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
by comparing the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
•
Consult your supplier or an experienced radio/TV technician for
assistance.
Warning
:
Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the user’s
authority to operate this equipment.
Information for Your Safety
Please read these safety instructions and the operation instructions
provided in this manual before operating the modem or the battery
charger.
SAR
(RF Absorption Levels into body)
Your modem contains a low power transmitter and receiver. When it is
switched on, it receives and sends out radio frequency (RF) signals. In
August 1996, the Federal Communications Commission (FCC)
adopted RF exposure (SAR) guidelines with safety levels for handheld
wireless devices. These guidelines are consistent with safety standards
previously set by both USA and International Standards: ANSI C95.1
(1992), NCRP Report 89 (1986), ICNIP (1996).
The modem is designed for handheld operation and has been certified
to comply with the aforementioned FCC guidelines and standards
under worst case conditions (zero separation distance). To maintain
the optimum operational characteristics, no part of the human body
should be in contact with the antenna during use.
